HondaSUV Forums - Discussion forum and bulletin board for Honda CR-V, CRV, Element, Pilot, HR-V owners
 

Go Back   HondaSUV Forums - Discussion forum and bulletin board for Honda CR-V, CRV, Element, Pilot, HR-V owners > Honda Pilot Forums > Pilot::Clinical Rounds

Pilot::Clinical Rounds Routine maintenance, problems, solutions and repair

Reply
 
Thread Tools Display Modes
  #1  
Old 08-03-2010, 08:38 PM
newbie888 newbie888 is offline
Junior Member
HondaSUV junior in training
 
Join Date: Sep 2008
Posts: 14
Default 2003 Honda Pilot SRS light

My pilot SRS light stay lit all the time. I tried resetting it using the 2-wires shorting method (I found on the web) but it won't go off. I searched the web and found the problem maybe the OPDS Control Unit/OPDS Sensor. How can I find out if this is the bad component? Is there something I can try? How can I reset it? If it turns out to be a bad OPDS Control Unit/OPDS Sensor, is it easy and safe to fix it myself?

Thank you in advance.
Reply With Quote
  #2  
Old 08-04-2010, 05:40 AM
sgtsandman's Avatar
sgtsandman sgtsandman is offline
Moderator
HondaSUV Elder
 
Join Date: Mar 2004
Location: Aliquippa, PA
Posts: 10,476
Default

A lot of times, it's a bad sensor in one of the front seat belts. There is a lifetime warranty on seat belts, so it might be worth taking it to the dealer for them to have a look.
__________________
Mike: Sgtsandman's 'V
2011 Ford Ranger XLT, 4X4 5 MT


1999 Honda CR-V EX RT4WD 5 MT


Reply With Quote
  #3  
Old 08-04-2010, 07:36 AM
chiph's Avatar
chiph chiph is offline
Senior Member
HondaSUV Mentor
 
Join Date: Nov 2003
Location: Austin TX, USA
Posts: 3,055
Default

You'll need the dealer's HDS test unit to read the codes from the SRS computer, so go ahead and schedule a visit.

Chip H.
__________________

Former owner of: 2012 Civic LX, 2006 Ridgeline RTL, 2000 Honda CRV EX
Reply With Quote
  #4  
Old 08-04-2010, 10:30 AM
'Curly Q Links''s Avatar
'Curly Q Links' 'Curly Q Links' is offline
Senior Member
HondaSUV Elder
 
Join Date: Feb 2004
Location: Alberta, Canada
Posts: 10,893
Default

Page 8 of the PDI sheets for the '03 PILOT is very interesting, but I don't know if any of the smaller connectors mentioned will help our friend do 'blink codes'.

The PDI sheets are 'must-read' material for any owner.


__________________
.
'97 CR-V. . . . . . '00 CR-V SE (leather) . . . '98 Odyssey V-Tec ! !
--------------------
First, read the Owner's Manual, then SEARCH, your Internet is STILL WAY faster than mine.
--------------------

Last edited by 'Curly Q Links'; 10-31-2010 at 05:27 PM. Reason: cleaned up link
Reply With Quote
  #5  
Old 10-19-2010, 06:25 PM
newbie888 newbie888 is offline
Junior Member
HondaSUV junior in training
 
Join Date: Sep 2008
Posts: 14
Default

I finally fixed the SRS light issue. It took me a while with many tries and searches on the net for the solution. It's been 2 days and the SRS is still off. Thanks for all the help!

(note: these instructions are cut/paste from the net)

Here's how I resolved it in case someone else runs into the some problem.

1) Reset my Maintenance light. It was flashing 10 times each time I start my car. I tried step #2 - Reset SRS light a few times w/o doing this step 1st and the SRS light wouldn't reset. This step may not be necessary.

a) Turn the key to the II position
b) Turn the key to the off position, and push and hold in the odometer reset button
c) Turn the key back to the II position, while still holding the reset button.
d) After about 10-15 seconds, the light should go off.

2) Reset SRS light

a) You need to find the MES Connector. On my car it was plugged into the side of the fuse box. It was yellow in color and was a 2 prong connector. The insulating material around the wires of the connector was also yellow. Wherever your connector is located, it is plugged into a "dummy harness." Hence, the prongs are not actually plugged into anything; the "dummy harness" just holds the MES Connector and prevents it from bouncing around.
b) Clip one alligator clip to one of the prongs and the other alligator clip to the other prong. If you're using 2 strands of wire, you won't be clipping, but twisting or shoving the wire into the respective prongs.
c) Hold the two ends of your wire together, so that they are now connected.
d) Keeping the wires connected, turn the ignition on (Do NOT start your car).
e) The SRS light comes on for about 6 seconds and then goes off. Quickly disconnect the two wires.
f) The SRS light will come on again. Quickly reconnect your wires.
g) The SRS light goes off. Disconnect your wire connection and leave the wires disconnected.
h) If you did this correctly, the SRS will blink twice.
i) Turn the ignition off and wait 10 seconds.
j) Turn the ignition on, thus starting your car, and hopefully the SRS light will now be off.
k) Turn your car off, assuming the above instructions worked and your SRS light is now off. If not, either retry the instructions and/or verify that nothing else is wrong.
l) Remove your wires, do not cross them at all or let them touch. Replug the yellow/green connector back into the "dummy harness".
m) If the SRS light comes back on (assuming you reset the SRS correctly and the light was off), then something is malfunctioning in the SRS Airbag System and you'll have to see a dealership or repair shop.
Reply With Quote
  #6  
Old 10-30-2010, 08:59 PM
zanzarista zanzarista is offline
Junior Member
HondaSUV Newbie
 
Join Date: Oct 2010
Posts: 3
Default

I had the same SRS light issue on my 2003 Pilot EX.
I had performed the reset process and was trying to get the SRS to come back on, because I had reset it once before and my wife told me "it just came back on while driving around".
I stopped the car and was about to get out to change seats from driver to passenger to see if I could make the light return and by chance, noticed that when I unbuckled the seat belt by pushing the release button, the seat belt warning light on the dash came on and then went out. This event was immediatly followed by the presence of the SRS light.
When I arrived home, I sprayed some contact cleaner and then some WD 40 into the seat belt blade reciever. So far, no repeat of the SRS light!!
Hope this helps some one stay out of the $tealers work area.
Ciao
Z.
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
2003 Honda Pilot engine light on - Diagnostic Trouble Code P0740 newbie888 Pilot::Clinical Rounds 7 02-18-2009 07:20 PM
2003 Honda Trail Pilot Norad2000x OFf-ToPiC FuN 17 08-09-2007 10:46 AM
Head light Assembly 2003 Pilot Anonymous Pilot::Clinical Rounds 0 07-13-2006 02:25 PM
F/S 2003 Honda Pilot EX Casanewt Pilot::Personal Classifieds 0 01-31-2006 09:05 PM
Question on 2003 Honda Pilot linux4guru Pilot::General Opinions, Commentaries and Observations 4 04-08-2005 02:20 AM


All times are GMT -7. The time now is 04:45 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
We are not affliated with Honda Motor Corp. The Honda name and logo are registered trademarks of American Honda Corporation in the United States and/or other countries. All rights reserved world-wide. Copyright 2006.